AEG LF62CS86 - The Inlet Hose

WARNING!
Do not put cardboard, wood or equivalent
materials below the appliance feet to
adjust the level.
x4
The appliance must be level and stable.
A correct adjustment of the appliance
level prevents the vibration, noise and
the movement of the appliance when in
operation.
When the appliance is installed on a
plinth or a tumble dryer is stacked on the
washing machine, use the accessories
described in chapter 'Accessories'. Read
carefully the instructions supplied with
the appliance and with the accessory.
5.3 The inlet hose
1. Connect the water inlet hose to the back
of the appliance if needs. Usually, it is
already installed at the factory.
20º20º
45º45º
2. Position it toward left or right depending
on the position of the tap. Make sure that
the inlet hose is not in vertical position.
3. If necessary, loose the ring nut to set it in
the correct position
4. Connect the water inlet hose to the cold
water tap with 3/4" thread.
Some model can contain inlet hose with
water stop device. It prevents any leaks in the
hose because of its natural ageing. The
sector in the window shows this fault A. If this
occurs, close the water tap and contact the
authorized service center for information to
replace the hose.
3/4”
3/4”
A
A
A
WARNING!
The inlet water shall not exceed 25 °C.
42 ENGLISH