AEG LF62CS86 - Acoustic Signals; Operating Hours Counter; Daily Use; Activating the Appliance

9.2 Acoustic signals
The acoustic signals operate when the
programme is completed (sequence of
sounds for about 2 minutes).
To deactivate/activate the acoustic signals,
touch the Startuitstel - Départ Différé and the
Tijd besparen - Gain de temps buttons
simultaneously for about 6 seconds.
If you deactivate the acoustic signals,
they continue operate when the
appliance has a malfunction.
9.3 Permanent Extra Rinse
With this option you can permanently have an
extra rinse when you set a new programme.
• To activate/deactivate this option touch
the Temp. button and the Centrifugeren -
Essorage button simultaneously until
relevant indicator
comes on/goes off
on display.
9.4 Operating Hours Counter
It is possible to visualise the total operating
time of the appliance in hours, starting from
the first switching on. This value will count
operating time of the cycles (does not include
pauses, delayed start time). To visualise this
value, proceed as follows:
1. Switch the appliance on by pressing
Aan /Uit - Marche/Arrêt button.
2. Turn the programme knob to the Eco
40-60 programme (1st position
clockwise).
3. Press and hold the Startuitstel - Départ
Différé and Tijd besparen - Gain de
temps buttons for some seconds (within
10 seconds after the switching on. After
these 10 seconds, the key combination
activates and deactivates the acoustic
signals).
4. After 3 seconds the total hours operated
by the appliance are shown in the display:
e.g. 1276 hours, the display shows the
text Hr for 2 seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens and
units).
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
9.5 Factory Reset
This function allows to restore the factory
default options. To activate this option follow
steps below:
1. Switch the appliance on by pressing
Aan /Uit - Marche/Arrêt button.
2. Turn the programme knob to the
Synthetica - Synthétiques programme
(3rd position clockwise).
3. Press and hold the Startuitstel - Départ
Différé and Tijd besparen - Gain de
temps buttons for some seconds (within
10 seconds after the switching on. After
these 10 seconds, the key combination
activates and deactivates the acoustic
signals).
4. The display will show
for about 5
seconds.
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
10. DAILY USE
WARNING!
Refer to Safety chapters.
10.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
ENGLISH 51