10. SETTINGS
10.1 Child Lock
With this option you can prevent that the
children play with the control panel.
• To activate/deactivate this option, press
and at the same time until the
indicator
comes on/goes off.
You can activate this option:
• After you press : the options and the
programme knob are locked.
• Before you press : the appliance
cannot start.
10.2 Permanent Extra Rinse
With this option you can permanently have an
extra rinse when you set a new programme.
• To activate/deactivate this option press
and at the same time until the
indicator
comes on/goes off.
10.3 Acoustic signals
The acoustic signals operate when:
• The programme is completed.
• The appliance has a malfunction.
To deactivate/activate the acoustic signals,
press and at the same time for 3
seconds.
If you deactivate the acoustic signals,
they continue operate when the
appliance has a malfunction.
10.4 Operating Hours Counter
It is possible to visualise the total operating
time of the appliance in hours, starting from
the first switching on. This value will count
operating time of the cycles (does not include
pauses, delayed start time). To visualise this
value, proceed as follows:
1. Switch the appliance on by turning the
programme knob to the Eco 40-60
programme (1st position clockwise).
2. Press and hold the and buttons for
some seconds (within 10 seconds after
the switching on. After these 10 seconds,
the key combination activates and
deactivates the acoustic signals).
3. After 3 seconds the total hours operated
by the appliance are shown in the display:
e.g. 1276 hours, the display shows the
text Hr for 2 seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens and
units).
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
10.5 Factory Reset
This function allows to restore the factory
default options. To activate this option follow
steps below:
1. Switch the appliance on by turning the
programme knob to the Synthetics
programme (3rd position clockwise).
2. Press and hold the
and buttons for
some seconds (within 10 seconds after
the switching on. After these 10 seconds,
the key combination activates and
deactivates the acoustic signals).
3. The display will show
for about 5
seconds.
If the procedure does not work (due to
timeout, wrong programme dial position
or wrong keys combination), switch the
appliance off and repeat sequence from
the beginning.
18 ENGLISH
To Next Page
Loading...
