11. BEFORE FIRST USE
During installation or before first use you
may observe some water in the
appliance. This is residual water left in
the appliance after a full functional test in
the factory to ensure the appliance is
delivered to customers in perfect working
order and is no cause for concern.
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Put a small quantity of detergent in the
compartment for washing phase.
4. Set and start a programme for cotton at
the highest temperature without laundry.
This removes all possible dirt from the drum
and the tub.
12. DAILY USE
WARNING!
Refer to Safety chapters.
12.1 Loading the laundry
1. Open the appliance door
2. Empty the pockets and unfold the items
before you put them in the appliance.
3. Put the laundry in the drum, one item at a
time.
Make sure not to put too much laundry in the
drum.
4. Close the door firmly.
Make sure that no laundry gets caught
between the seal and the door to avoid
risk of water leakage and damage to the
laundry.
Washing heavily oiled, greasy stains
could cause damage rubber parts of the
washing machine.
12.2 Detergent compartments. Using and additives
1. Measure out specified detergents and the
fabric conditioner.
2. Put the detergent and the fabric conditioner
into the proper compartments.
3. Carefully close the detergent drawer.
ENGLISH 19
To Next Page
Loading...
