AEG LFX50844B - 12.4 Setting a programme; 12.5 Starting a programme without the delay start; 12.6 Starting a programme with the delay start; 12.7 The AutoSense System load detection

When you want to return use powder detergent:
A
1. Remove the drawer.
2. Adjust the flap in up position.
3. Put back the drawer in the recess.
Make sure that the flap does not cause a
blockage when you close the drawer.
12.4 Setting a programme
1. Turn the programme knob and set the
programme:
• The indicator flashes.
• The display shows the level of the
Time Manager, the programme
duration and the indicators of the
phases of the programme.
2. If necessary, change the temperature and
the spin speed or add available options.
When you activate an option, the
indicator of the set option comes on.
If you set something incorrect, the display
shows the message .
12.5 Starting a programme without
the delay start
Press .
• The indicator of stops to flash and
stays on.
• The indicator starts to flash on the
display.
• The programme starts, the door locks,
the display shows the indicator .
• The drain pump can operate for a
short time when the appliance fills
water.
After approximately 15 minutes from the
start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
12.6 Starting a programme with the
delay start
1. Press again and again until the
display shows the delay you want to set.
The related indicator comes on the display.
2. Press :
• The appliance starts the countdown.
• The door locks, the display shows the
indicator .
• When the countdown is completed,
the programme starts automatically.
You can cancel or change the set of the
delay start before you press the . To
cancel the delay start:
• Press to set the appliance to
pause.
• Press until the display shows
'.
• Press again to start the
programme immediately.
12.7 The AutoSense System load
detection
After touching the Start/Pause button:
1. The AutoSense System starts estimating
the weight of the load to calculate the real
programme duration. During this phase
the display shows the simple animation.
2. After about 10-15 minutes new cycle
duration is displayed.
The appliance automatically adjusts the
programme duration to the load to
achieve perfect washing results in the
minimum possible time.
ENGLISH 21