3.
4.
14.8 Cleaning the inlet hose and the valve filter
14.9 Frost precautions
If the appliance is installed in an area where
the temperature can be less than 0° C,
remove the remaining water from the inlet
hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install the
inlet hose again.
WARNING!
Make sure that the temperature is higher
than 0 °C before you use the appliance
again.
The manufacturer is not responsible for
damages caused by low temperatures.
ENGLISH 27
To Next Page
Loading...
