3. Press and hold the Time Dry and the
Auto Dry buttons simultaneously for a few
seconds until a 'click' sounds. Release
the buttons. appears on the display
for 5 seconds and the indicator starts
blinking.
The wireless module begins starting up.
Make sure that your APP is ready for
connection.
4. After about seconds, (Access Point)
appears on the display.
The access point will be open for about 3
minutes.
As long as the appliance is activated, it
will keep trying to connect with saved
credentials until the Wi-Fi is deactivated
or resets the credentials.
5. Configure the "My AEG" app on your
smart device and follow the instructions to
connect the appliance to your Wi-Fi
network.
6. If the connectivity is configured, when the
programme information screen returns,
the indicator is on the display.
To switch the wireless connection off,
press and hold the Time Dry and the Auto
Dry buttons simultaneously for a few seconds
until the first acoustic signal. Release the
buttons. appears on the display for 5
seconds.
If you switch the appliance off and on
again, the wireless connection is
automatically off.
To remove the wireless credentials, press
and hold the Time Dry and the Auto Dry
buttons simultaneously for 10 seconds until
the second acoustic signal: appears on
the display.
9.4 Remote Start
The Remote Start enables you to start a cycle
in remote control.
The Remote Control activates
automatically when you press the Start /
Pause button to start the programme,
but it is also possible to start a washing
programme remotely.
When the App is installed and the wireless
connection is complete, you can activate the
Remote Start:
1. Touch the Delay Start button and the
indicator appears on the display for
a few seconds.
ENGLISH 35
To Next Page
Loading...
