2. Touch the Start / Pause button to
activate the Remote Start before the
indicator stops blinking.
The indicators and appear on the
programme summary screen and the door is
locked. Now it is possible to start the
programme remotely.
When touching the Start / Pause
button after the indicator stops
blinking, the Remote Start is not
activated, but the set programme starts.
To remove the Remote Start, tap on the
Delay Start
button and confirm by
pressing the Start / Pause button.
The reset position deactivates the
Remote Start.
9.5 Over-the-air update
The App may propose an update for your
appliance.
The update is accepted via App only.
If a programme is running, the App notifies
that the update will start at the end of the
programme.
During the update, the appliance shows
in the display.
Do not switch off or unplug the appliance
during update.
The appliance will be usable again at the end
of the update, without any notification about
successful update.
If an error occurs, the appliance shows
in the display: just press any buttons or turn
the knob to return to normal use.
10. SETTINGS
10.1 Acoustic signals
This appliance has different acoustic signals,
that operate when:
• You activate the appliance (special short
tune).
• You deactivate the appliance (special
short tune).
• You touch the buttons (click sound).
• You make an invalid selection (3 short
sounds).
• The programme is completed (sequence
of sounds for about 2 minutes).
• The appliance has a malfunction
(sequence of short sounds for about 5
minutes).
To activate/deactivate the acoustic signals
when the programme is completed, touch the
Wash Mode and the Prewash buttons
simultaneously for about 2 seconds. The
display shows On or Off.
If you deactivate the acoustic signals,
they continue to operate when the
appliance has a malfunction.
36 ENGLISH
To Next Page
Loading...
