Only for selected countries
In case of exhaust installation a window
switch might be required (consult an
authorised technician). You need to buy it
separately as it is not supplied with the
hob. The window switch has to be
installed by an authorised technician.
Refer to the installation booklet.
If the appliance is installed above a drawer,
the hob ventilation can warm up the items
stored in the drawer during the cooking
process.
Find the video tutorial "How to install your
AEG Extractor Hob" by typing out the full
name indicated in the graphic below.
www.youtube.com/electrolux
www.youtube.com/aeg
How to install your AEG
Extractor Hob
Filter housing assembly
Before the first use make sure to insert the
filter inside the housing with the black sides
facing inwards and the silver sides facing
outwards. Refer to "Cleaning the hood filter".
Once the filter housing is assembled, put it
inside the hood system and place the grid on
the hood.
3.4 Connection cable
• The hob is supplied with a connection
cable.
• To replace the damaged mains cable, use
the cable type H05BB-F or H03V2V2-F
which withstands a temperature of 90 °C
or higher.
• The single wire must have a diameter of
minimum 1,5 mm².
• Speak to your local Service Centre. The
connection cable may only be replaced by
a qualified electrician.
WARNING!
All electrical connections must be made
by a qualified electrician.
8 ENGLISH
To Next Page
Loading...
