2. Motion clear time.
This configures the clear time when your motion sensor times out and sends a no motion status.
Parameter # Size Value Description
2 2 1-32767 Clear/timeout time in seconds.
DEFAULT SETTING = 240
3. Motion sensitivity.
This setting configures the sensitivity of Motion Sensor where 0 is disabled, 1 is lowest sensitivity, and 11 is
maximum sensitivity.
Parameter # Size Value Description
3 1 0-11 Sets motion sensitivity.
DEFAULT SETTING = 11
4. Enable/Disable Binary Sensor
This setting is used to enable Binary Sensor Reports which is used for gateways that use the older style of motion
reports. If you do not see status changes over your motion sensor, you must enable this setting.
Command Class
COMMAND_CLASS_SENSOR_BINARY
Command
SENSOR_BINARY_REPORT
Type
MOTION (0x0C)
Event
Detected (0xFF) / No-detected (0x00)
Parameter # Size Value Description
4 1 0 Disables Binary Sensor Report
1 Enables Binary Sensor Report
DEFAULT SETTING = 0
Group Association for direct control.
The TriSensor has 2 group control points to directly control Z-Wave devices without your gateway. Below is a table of
the available Group Association that you can set to the TriSensor to directly control your Z-Wave Switches and
Dimmers from within your gateway.
Group
Association #
Function
2
Motion Trigger = turn on device
No Motion Trigger = turn off device.
3
Temperature > Threshold = turn on
device.
Temperature <= Threshold = turn off
device.
What is a Group Association?
To Next Page
Loading...
