Aeotec TriSensor - Page 13

29-1-2019 TriSensor user guide. : Aeotec
https://aeotec.freshdesk.com/support/solutions/articles/6000195459-trisensor-user-guide- 13/18
6 1 0
Send BASIC_SET = 0xFF to devices associated in
Group 2 when motion event is triggered,
send BASIC_SET = 0x00 to devices associated in
group 2 when motion event is cleared.
1
Send BASIC_SET = 0x00 to devices associated in
Group 2 when motion event is triggered,
send BASIC_SET = 0xFF to devices associated in
group 2 when motion event is cleared.
2
Send BASIC_SET = 0xFF to devices associated in
Group 2 when motion event is triggered.
3
Send BASIC_SET = 0x00 to devices associated in
Group 2 when motion event is
triggered.
4
Send BASIC_SET = 0x00 to devices associated in
Group 2 when motion event is cleared.
5
Send BASIC_SET = 0xFF to devices associated in
Group 2 when motion event is cleared.
DEFAULT SETTING = 0
7. Temperature Alarm Setting (Group 3 control).
This parameter is configured the threshold value that alarm level for temperature. When the current ambient
temperature value is larger than this configuration value, TriSensor will send a BASIC_SET = 0xFF to nodes
associated in group 3. If current temperature value is less than this value, device will send a BASIC_SET = 0x00 to
nodes associated in group 3.
This setting is great for the control of Air Conditioners.
Parameter
#
Region Size Value Default
7 EU/AU 2
-400
- 850
239 C
US 2
-400
-
1185
750 F
LED control settings.
You can control what colors the LED blinks when certain events happen for: Motion, Temperature, Light, Battery, and
Wakeup.
11. Enable or Disable LED over TriSensor
This completely disables all LED reaction regardless of Parameter 10 - 15 settings.
Parameter = 10
Size = 1 Byte
Values and description;
0 = Disable LEDs
1 = Enable LEDs [Default]
1. Motion report LED.
This setting changes the color of the LED when your TriSensor sends a motion report.