AEP transducers MP2C - LOAD CELL AND TRANSDUCER CONNECTION (6 WIRES)

To Next Page

To Previous Page

MP2C

Manuale operativo - Operating manual MO.MP2C.518

Pag. 51

Collegamento: CELLE DI CARICO e TRASDUTTORI 2 o 3 mV/V

6 fili (Connettore DB9 Femmina)

Connection: LOAD CELLS and TRANSDUCERS 2 or 3 mV/V

6 wires (DB9 Female connector)

Lo strumento viene fornito con la connessione a 4 fili, per impostare

il sistema a 6 fili è necessario aprire i due jump 6w all' interno dello

strumento tra i terminali 3-8 e 4-9 del connettore DB9.

1 = SEGNALE + (Bianco)

2 = SEGNALE – (Giallo)

3 = ECCITAZIONE + (Rosso)

4 = ECCITAZIONE – (Nero)

8 = SENSE + (Arancio)

9 = SENSE – (Blu)

SCHERMO collegato al corpo metallizzato del connettore.

Colori riferiti al cavo standard AEP transducers.

Instrument is supplied with the 4 wires connection in order to set the

6 wires system it is necessary to open the 6w jumps placed inside

the instrument between 3-8 and 4-9 terminals of the DB9 connector.

1 = SIGNAL+ (White)

2 = SIGNAL- (Yellow)

3 = EXCITATION+ (Red)

4 = EXCITATION- (Black)

8 = SENSE+ (Orange)

9 = SENSE- (Blue)

SHIELD is connected to the connector metal housing.

Colors are referred to AEP transducers standard cable.