Figure 9: West indicator
Now look at the bubble level. The bubble should be fully inside the red circle. If it is not,
wind direction, speed, and rain readings may not operate correctly or accurately. Adjust
the mounting pipe, as necessary. If the bubble is close, but not quite inside the circle,
and you cannot adjust the mounting pipe, you may have to experiment with small
wooden or heavy cardboard shims between the sensor package and the top of the
mounting pole to achieve the desired result (this will require loosening the bolts and
some experimentation).
Make sure you check, and correct if necessary, the westly orientation as the final
installation step, and now tighten the bolts with a wrench.
6. Reset Button and Transmitter LED
Using a bent-open paperclip, press and hold the RESET BUTTON (see Figure 10) to
affect a reset: the LED remains off while the RESET button is depressed, and will turn
on for four seconds once you release the button. The LED should then resume as
normal, flashing approximately once every 48 seconds.
To Next Page
Loading...
