Setting Up
The base station has six keys for easy operation: the MENU key, UP key, DOWN key,
ENTER key, HISTORY key and the ON/OFF key.
Note: Keeping the UP or DOWN key pressed when setting certain units will
increase/decrease digits in greater steps.
The setting procedure can be exited at any time by either pressing the HISTORY key or
waiting for the 30-second time-out to take effect.
The basic settings can now be performed as follows:
Time
Press the MENU key to select the TIME section, the TIME section digits will start flashing
and you will be in the LCD contrast setting mode (level 1-8, default level 5), press the UP
or DOWN key to set the value. Level 1 will produce the faintest appearance whereas
level 8 is the darkest.
Press the ENTER key to select the following:
Time zone
12/24h time display (default 12h)
Manual time setting (hours/minutes)
Press the UP or DOWN key to set each value.
Note: Set your time zone to be your offset against UCT-1 as follows:
To Next Page
Loading...
