Aercus WS3085 - Page 26

Aercus
Instruments™
-
WS3085
26
|
P a g e
Light
Press the MENU key twelve times to select the LIGHT section, the LIGHT section digits
will start flashing. Press the UP or DOWN key to change the light intensity display mode
between W/M
2
, FC and LUX.
Press the ENTER key to select the following modes, then press the UP or DOWN key to
set the value:
 Light intensity high alarm (press ON/OFF to enable/disable). If the alarm is
enabled, an alarm symbol appears in the display.
 Maximum light intensity value (since last reset). Resetting the maximum
light intensity value - when both the light intensity value and MAX icon are
flashing, hold the ENTER key for 3s, the maximum light intensity value will be
reset to the current reading.
Rain
Press the MENU key thirteen times to select the RAIN section, the RAIN section digits
will start flashing. Press the UP or DOWN key to change the period over which rain is
measured (1h, 24h, Week, Month and Total rain). Note: The 24h setting resets at
midnight each day.
Press the ENTER key to select the following modes, then press the UP or DOWN key to
set the value:
 Rainfall units - select between mm and inch.
 Rain high alarm (press ON/OFF to enable/disable). If the alarm is enabled,
an alarm symbol appears in the display.