EN
21.11 - 6755517_05
10
MODUCONTROL
CONTROL PANEL
5.6. ELECTRIC COMPONENTS
Electric Control Board
controls and safety devices. It is in compliance with
-
The electric control board can be accessed by re-
moving the voltage. Act on the opening lever of the
control board itself. This lever can be locked using
one or more padlocks during maintenance interven-
accidentally.
Control board
Allows complete control of the appliance.
the user manual.
compressors magnet circuit-breaker pro
-
-
ature probes
Gas temperature probe one on the for
pressing line and coil
External air temperature probe
MODU CONTROL
Temperature control of the output water with proportional-integral
algorithm: maintains average output temperature at value set
- Self-adapting differential switch: guarantees minimum functioning
times of the compressor in systems with low water content.
- Intelligent defrosting for pressure reduction: allows to determine
when the coil is effectively defrosted, avoiding useless defrosting
- Set-point compensation with external temperature: reduces energy
consumption
- Pre-alarms with automatic reset: in the case of alarm, a certain
number of re-starts are allowed before the definitive block
blocked cycle reversing valve
- Compressor functioning hours count.
- Compressor peak count.
- Historical alarms
- Autostart after voltage drop.
- Local or remote control
Display of the start of the unit:
1.
2.
3.
4.
1. Water outlet
2. water inlet
3.
4. Pressing gas temperature
5.
6.
7.
8.
9.
10. Alarms management:
11. Low pressure
12. High pressure (primary alarm: switch directly blocks supply to
13. High discharge temperature
14.
15.
-
fore blocking.
Change season from external contact
To Next Page
Loading...
Need help?
General
