AERMEC FCA-R Series Directions For Use

20
USE OF THE REMOTE CONTROL
– Use the remote control directed owards the receiver of the fan coil.
If the impulses are received properly, a beep will be heard from the fan coil.
– No obstacles must be allowed between transmitter and receiver.
– The remote control can transmit its impulse within 7 meter distance from the receiver.
LIQUID CRYSTAL DISPLAY
a - TRANSMISSION INDICATOR
It appears every time any button is pushed to show the transmission of the impulse.
b - TIME (hr)
It is displayed only when the timer is being programmed or ON.
c - TIMER SYMBOL
It is displayed when the timer is being programmed or ON.
d - TEMPERATURE AND TIME
The temperature set is displayed when the heating or cooling programs are selected.
On automatic and dehumidification modes figures shows variations of pre-set temperature
values.
The time is displayed only when the timer is being programmed or ON.
e - FAN SPEED
The fan speed selected is shown by the symbol:
= automatic
= minimum
= medium
= maximum
f - TYPE OF OPERATION
The type of operation selected is indicated by the symbol:
= automatic
= heating (only ECA heating pump)
= cooling
= dehumidification
g - DEGREES (°C)
The “°C” symbol is displayed with the temperature set value.
NOTE:
– When the batteries are replaced, all indicators on the display go to AUTO.
If the fan coil is switched off all previous settings are stored.
– Do not leave the remote control near a heat source or under direct sun rays.
Do not expose at excessive humidity or shocks to avoid deformations, breaks or color losses.
g
b
cde
f
a
BATTERIES
Use 2 manganese or alkaline 1,5 V, high performance batteries: R 03 (AAA).
To replace the batteries:
– Push the battery cover of the remote control and slide as marked by the arrow.
– Replace the batteries keeping the polarity as marked by the signs.
Important
– The batteries last 10 months approx. if used normally.
– The two batteries must be the same.
– Remove the batteries from the remote control if not used for long time.
– When the remote control works only close to the receiver, change the batteries.
GB

AERMEC FCA-R Series Specifications

General

Brand	AERMEC
Model	FCA-R Series
Category	Fan
Language	English