19
Aermec. 16.01. 5140901_01
To replace the batteries of the infra red
remote control proceed as follows:
• Press the tab “ ” located on the back
of the remote control. Open the battery
cover by sliding it in the direction of the
arrow.
• Remove the old batteries.
• Insert new alkaline high performance
LR03 (AAA) 1.5V batteries (penlight)
batteries, being careful not to invert the
polarity.
• Close the battery cover.
NOTE:
When batteries are replaced use new
batteries of the recommended type.
Remove the batteries if the remote control
is not used for extended periods.
The remote control can emit a signal up to
a maximum distance of 8 metres.
The unit may be influenced by signals
transmitted by remote controls of
televisions, neon lights or wireless
telephones/devices or other equipment
used in the same room.
13.1. REPLACING THE REMOTE CONTROL
BATTERIES
AAA 1.5V
batteries
Battery housing
cover
To Next Page
Loading...
