8 21.05 – 5167557_02
DISEGNO SPECIFICO DEL MODELLO-
SOLLEVAMENTO UNITÀ CON CINGHIE,
CORDE O FUNI
Packaging label
Technical plate
RECEPTION
TRANSPORT AND HANDLING
The unit must be handled by qualied personnel. Carefully follow the
lifting instructions on the labels placed on the unit.
The unit must be lifted with extreme care to prevent knocks to the frame,
panels, electrical panel, etc..
NOTE: Plastic elements can be used to protect the units against damage
during transport. The machine is also wrapped in packaging. We recom-
mend keeping this protection during all transport and lifting operations
and not remove the plastic elements until commissioning.
If the unit has anti-vibration supports, they must be installed on the unit
before nal positioning.
Inspection upon receipt
Perform the following check upon receipt of the product.
- Check that the exterior has not been damaged in any way.
- Check that the lifting and transport devices are appropriate to the
type of equipment and compliant with the transport and handling
instructions attached to this manual.
- Check that the accessories required for on-site installation have been
delivered and are operational.
- If the unit is provided pre-loaded with refrigerant, make sure there have
been no leaks.
- Check that the equipment supplied corresponds to the order and
delivery note
Product identication
The Aermec products can be identied by the packaging label bearing
the identication data of the product and by the technical plate bearing
the performance and technical data of your unit.
If the product is damaged, send a registered letter with the details of
the problem to the shipping company within 48 working hours from
delivery.
LIFTING
Before lifting the unit, place protections between the belts (or ropes and
chains) and the framework to prevent damage to the structure.
CAUTION: ALWAYS USE ALL THE UNIT LIFTING POINTS PROVIDED
• Follow all safety regulations and standards
• Wear safety glasses, work gloves and safety shoes
• Pay the utmost attention to heavy and bulky equipment during lifting
and handling, and when placing it on the ground.
• All panels must be tightly xed before moving the unit
• Before lifting, check the specic weight on the technical plate.
• Use all, and only, the lifting points indicated;
• Use ropes in compliance with Standards and of equal length;
• Use a spacer in accordance with the sling (not included) see drawing
• Handle the unit with care and without sudden movements
• Do not stand under the unit during lifting
Attention: the units cannot be stacked
RECEPTION
Packaging label
Technical plate
Motor data plate
To Next Page
Loading...
Need help?
General
