Need help?Do you have a question about the AERMEC NRGI and is the answer not in the manual?
Initial operations after powering the unit.
Explains the function of each key on the control panel.
Overview of how functions and information are organised into menus.
Displays the unit's general status and parameters.
Displays the system's general status and parameters.
Displays the cooling circuit's general status.
Displays the status of the free cooling circuit.
Displays the status of the total recovery system.
Summarizes fan states and setpoints.
Shows the state of the defrosting process.
Displays inlet/outlet water temperatures.
Shows states of flow switch, high pressure, fan overload.
Shows states of secondary setpoint, flow switch, pump.
Shows states of heater/boiler, resistance, crankcase heater.
Displays values for modulating fan group and valve.
View and control the general state of the system.
Select the unit's operating mode (Cooling, Heating, etc.).
Define time bands for system operation.
Set start and end dates for heating mode.
Set start and end dates for cooling mode.
Enable or disable the total recovery function.
Set the desired recovery work setpoint.
Set the system's date and time.
Configure automatic DST changes.
Enter the password to access the installer menu.
Select parameters for operating thermostat management.
Set recovery management temperatures and pump logic.
Configure system anti-freeze alarm settings.
Set function associated with multifunction input U10.
Set supplementary heater operation for low temperatures.
Displays operating hours of compressors.
Enable or disable the use of glycol water.
Set general parameters for Variable Primary Flow.
Displays unit code, software version, and test date.
Change the "Installer" menu access password.
Alarm related to phase monitoring.
Alarm for faulty evaporator input probe.
Alarm for faulty coil 1 temperature probe.
Initial operations after powering the unit.
Explains the function of each key on the control panel.
Overview of how functions and information are organised into menus.
Displays the unit's general status and parameters.
Displays the system's general status and parameters.
Displays the cooling circuit's general status.
Displays the status of the free cooling circuit.
Displays the status of the total recovery system.
Summarizes fan states and setpoints.
Shows the state of the defrosting process.
Displays inlet/outlet water temperatures.
Shows states of flow switch, high pressure, fan overload.
Shows states of secondary setpoint, flow switch, pump.
Shows states of heater/boiler, resistance, crankcase heater.
Displays values for modulating fan group and valve.
View and control the general state of the system.
Select the unit's operating mode (Cooling, Heating, etc.).
Define time bands for system operation.
Set start and end dates for heating mode.
Set start and end dates for cooling mode.
Enable or disable the total recovery function.
Set the desired recovery work setpoint.
Set the system's date and time.
Configure automatic DST changes.
Enter the password to access the installer menu.
Select parameters for operating thermostat management.
Set recovery management temperatures and pump logic.
Configure system anti-freeze alarm settings.
Set function associated with multifunction input U10.
Set supplementary heater operation for low temperatures.
Displays operating hours of compressors.
Enable or disable the use of glycol water.
Set general parameters for Variable Primary Flow.
Displays unit code, software version, and test date.
Change the "Installer" menu access password.
Alarm related to phase monitoring.
Alarm for faulty evaporator input probe.
Alarm for faulty coil 1 temperature probe.
To Next Page
General
