AERMEC NRGI - Configures the installer menu password

28
Installer
Push ENTER for change
Language: ENGLISH
8.38 CONFIGURATION OF THE UNITS OF MEASURE
This window is used to set the units of measure to use in the system:
STANDARD [°C/bar]
STANDARD [°C/bar]
Options
Supervisor BMS
Type of measurem.unit
Type of units of measure: indicates the units of measure shown on the display; the
possible states are:
— STANDARD [°C/bar]
— ANGLO-SAXON [°F/psi]
BMS supervisor: indicates the units of measure read by the supervisor; the possible
states are:
— STANDARD [°C/bar]
— ANGLO-SAXON [°F/psi]
8.39 CONFIGURES THE INSTALLER MENU PASSWORD
This window is used to change the “Installer” menu access parameter:
0000
Password
Installer:
New password