EasyManua.ls Logo

AERMEC NRK 0200 - Unit Configurator; Configuration Parameters

AERMEC NRK 0200
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7Aermec cod.
5167556_03 17.09
NRK 0200-0700
2. UNIT CONFIGURATOR
Field Code
1,2,3 NRK
4,5,6,7 Size
0200-0280-0300-0330-0350-0500-0550-0600-0650-0700 (1)
8 Field of application
° Termostatic expansion valve(2)
9 Model
H Heat pumps
10 Heat recovery
° Without recovery
D With Desuperheater
11 Version
A High efficiency
E High efficiency in low noise operation
12 Coil
° In aluminium
R In copper
S In tinned copper
V In painted aluminium-copper (epoxy paint)
13 Fans (3)
° Standard
M Increased
J High static pressure
Inverter
14 Alimentation
° 400V/3N/50Hz with circuit breakers
15-16 System integrated hydronic module (4)
00 without pumps or buffer tank
01 Buffer tank and
n° 1
low head static pressure pump
02 Buffer tank and
n° 2
low head static pressure pump
03 Buffer tank and
n° 1
high head static pressure pump
04 Buffer tank and
n° 2
high head static pressure pump
05
n°1 low head static pressure pump and buffer tank (with holes for immersion heaters) (5)
06
n°2 low head static pressure pump and buffer tank
(with holes for immersion heaters) (5)
07
n°1 high head static pressure pump and buffer tank (with holes for immersion heaters) (5)
08
n°2 high head static pressure pump and buffer tank
(with holes for immersion heaters) (5)
P1
n° 1
low head static pressure pump
P2
n° 2
low head static pressure pump
P3
n° 1
high head static pressure pump
P4
n° 2
high head static pressure pump
(2) The size 0200-0280-0300-0330 only available in low noise version "HL" and equipped with inverter fans as standard
(3) Leaving water temperature down to 4°C
(4) Standard on/off fans for sizes from 0350 to 0700
Increased on/off fans, option for sizes from 0200 to 0330
Standard Inverter fans for sizes from 0200 to 0330, without useful static pressure
Inverter fan, option for sizes from 0350 to 0700 with useful static pressure
(5) The buer tank with holes and supplementary electric heaters leave the factory with plastic protection caps. Before loading the system, if the installation of an electric heater
is not envisaged it is compulsory to replace the plastic caps

Related product manuals