AERMEC NXW - AFTER-SALES ASSISTANCE Menu - Operational Data; Evaporator Pump Functioning Hours; Compressors Functioning Hours; Condenser Pump Functioning Hours

54
AFTER-SALES ASSISTANCE menu - HORS WORKED sub-menu - Display of evaporator pump functioning hours
Visualisation on unit display Index Display
A Hour counter: Indicates the number of hours of work of the
components:
B Evaporator pump 1: indicates how many functioning hours of
the pump on the evaporator 1 (if present).
C Evaporator pump 2: indicates how many functioning hours of
the pump on the evaporator 2 (if present).
AFTER-SALES ASSISTANCE menu - HORS WORKED sub-menu - Display of compressors functioning hours
Visualisation on unit display Index Display
A Hour counter: Indicates the number of hours of work of the
components:
B Circuit 1: Indicates the number of the circuit to which the
compressors refer.
C/D/E
Compressor: indicates how many functioning hours of the
compressors present on the unit.
AFTER-SALES ASSISTANCE menu - HORS WORKED sub-menu - Display of condenser pump functioning hours
Visualisation on unit display Index Display
A Hour counter: Indicates the number of hours of work of the
components:
B Condenser 1 pump: indicates how many functioning hours of
the pump on the condenser 1 (if present).
C Condenser 2 pump: indicates how many functioning hours of
the pump on the condenser 2 (if present).
Work.hours
Evaporator pump 1:
A
B
0012h
C
Evaporator pump 2:
-- h
Work.hours
Compressor 1: 0006h
A
B
C
Compressor 2: 0003h
Compressor 3: -- h
Circuit 1
D
E
Work.hours
Condenser pump 1:
A
B
0012h
C
Condenser pump 2:
-- h
AFTER-SALES ASSISTANCE menu - Submenu CONFIG. BMS - Configuration of supervising service
Visualisation on unit display Index Display
A
Config. BMS: Indicates the settings for the supervising systems.
B Protocol: Indicates which communication protocol is used for
BMS; possible selections are:
• MODBUS;
• CAREL (use for LON Work protocol);
C Com. speed: Indicates the communication speed to be used, for
BMS management.
D Serial address: Indicates the address to be assigned to the unit;
this address allows BMS to communicate with the unit board.
E LON Work: Indicates whether to activate LON Work protocol.
Parametri modificabili dall’utente
Config. BMS
Conf.porta supervisione
A
Protocollo:
Velocita comun.: 19200
LON Works: NO
B
MODBUS
Indirizzo seriale: 1
D
C
E