EasyManuals Logo

AERMEC VED Series User Manual

AERMEC VED Series
77 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
IVEDITI 1707 - 4880981_01
DO NOT USE WATER THAT IS TOO HOT


coil. Do not use chemical products or sol-
vents to clean any part of the fan coil. Do not
spray water on internal or external surfaces

CLEAN THE FILTER PERIODICALLY
Frequent cleaning of the filter will ensure
more efficient operation.
Check if the filter is excessively dirty. Repeat
the operation more frequently, if required.
Clean often and use a suction device to
remove accumulated dust.
When the filter is clean, reassemble it onto
the fan coil by following the removal proce-
dure in reverse order.
EXTRAORDINARY CLEANING
Removing the augers of the inspected fans


cleaned accurately. This is essential for instal-
lation in very crowded areas or that require
high hygienic standards.
DURING OPERATION
Always leave the filter mounted on the fan
coil during operation, otherwise, the dust in
the air will dirty the surface of the coil.

When in cooling mode, water vapour can
come out of the fan coil air flow.
When in heating mode, a slight hissing sound
can be heard near the fan coil. The fan coil
may sometimes emit unpleasant odours due
to the accumulation of substances present

often, especially if the room is not aired out

During operation, noise and/or a creaking
sound may be heard from inside the device,
due to the heat expansion of the elements

indicate a fault and does not cause damage
to the unit unless the maximum input water
temperature is exceeded.

In case of anomalous operation, remove the
voltage from the unit and then re-apply it
and re-start the appliance.
ATTENTION! Do not try to repair the unit on
your own, as it may be very dangerous!
If the problem persists, call the Area After-
sales Service immediately.
DO NOT PULL THE ELECTRIC CABLE
It is very dangerous to pull, step on or crush
the power supply cable or secure it using
nails or staples. The damaged cable can
cause short circuits and injury to persons.
Do not introduce objects into air vents
Do not introduce objects in the air outlet and
inlet. This could cause injury to persons or
damage the fan.
ATTENTION
Do not allow the appliance to be used by
children or disabled people without appro-
priate supervision. Remember that children
must not use the appliance as a toy.

SA
SW
VC/FVCSA SW VC/FVCSA C/FC
SW VC/F
C/F
VC/FSA SW
C/F
SA SW
C/F
SW
C/FC VC/FVCC/FC VC/FVCSAVC/FVCSA
VC/FSA
C/F
VC/FSA
C/F
SA
C/F

SW Water temperature probe
VC/F 
VC 
SA Ambient temperature probe
C/F Coil 
C Coil 






Other manuals for AERMEC VED Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AERMEC VED Series and is the answer not in the manual?

AERMEC VED Series Specifications

General IconGeneral
BrandAERMEC
ModelVED Series
CategoryFan
LanguageEnglish

Related product manuals