5
Operation
Turn on the dehumidifier
Humidity control
Full water indicator
Releasing the water full alarm
When the unit is powered on, the buzzer beeps once, the screen will displays "--",
and the unit is in standby mode. After pressing the power button, the luminous
circle around the button lights up, and the screen displays the current ambient
humidity. The unit runs at high wind with the default target humidity of 60%,
and the compressor determines whether to start according to the ambient humidity.
Press the humidity button to to set the target humidity, and the compressor will
run with the current ambient humidity and the control humidity setting.
When the water tank is full, the indicator light will be red, and the buzzer will
remind you that the compressor, fan, and ion are all turned off at this time. After
the water-full state is released, it will automatically restore the power-on state
before the water-full state.
When the water tank is full of water alarm, press any button to cancel the
alarm sound.
To Next Page
Loading...