Aerogen Solo - Page 28

Aerogen
®
26
Table 2. Aerogen Pro-X Controller Troubleshooting (Continued)
If this happens: It could mean: Try this:
Medication is left in
the nebulizer after
nebulization cycle.
Nebulizerwasnotturned
onorconnectedtopower.
Ensure that nebulizer is
connectedtopowerand
turned on.
Rechargeable battery is
depleted.
Recharge battery (see
RechargingtheBattery).
A30Minutecyclewas
selectedwhenconnected
to the continuous feed
system.
Run a continuous cycle.
It may be time to replace
the nebulizer.
See Warranty and Life of
Product. Refer to Aerogen
Solo parts list by visiting
www.aerogen.com.
Flashing amber light.
It may mean that it is time
to replace controller.
Contact your local Aerogen
sales representative.
Note: The rechargeable battery in the Aerogen Pro-X Controller should
only be replaced by Aerogen authorized personnel: contact your Aerogen
sales representative.