Aerogen Solo - System Specifications

Aerogen
®
28
Specifications
Table 3. Physical Specifications of the Aerogen Solo System
Nebulizer Dimensions
67 mm H x 48 mm W x 25 mm D
2.6” H x 1.88” W x 1.1” D
Aerogen Pro-X Controller
Dimensions
33mm H x 75mm W x 131mm D
1.3” H x 2.9” W x 5.2”D
Controller Cable Length 1.8 m (5.9 ft.)
AC/DC Adapter Cable Length 2.1 m (6.7 ft.)
Nebulizer Weight 13.5 g (0.5 oz) nebulizer and plug
Aerogen Pro-X Controller Weight 230 g (8.1 oz.), including battery and cable
Nebulizer Capacity Maximum 6 mL
T-piece
Volume
Adult 34.3 mL
Pediatric (15 mm) 19.5 mL
Table 4. Environmental Specifications of the Aerogen Solo System
Operating
Maintains specified performance at circuit pressures up to 90cm
H2O and temperatures from 5 ºC (41ºF) up to 45 ºC (113ºF).
Atmospheric Pressure 450 to 1100 mbars
Humidity 15% to 95% relative humidity
Noise Level <35dBmeasuredat0.3mdistance
Storage & Transport
Transient Temperature
Range
-20 to +60°C (-4 to +140°F)
Atmospheric Pressure 450 to 1100 mbars
Humidity 15 to 95% relative humidity
Table 5. Power Specifications of the Aerogen Solo System
PowerSource
FRIWO (AG-AP1040-US) AC/DC adapter (input 100 to 240 VAC
50 – 60 Hz, output 9 V) or internal rechargeable battery (4.8 V
nominal output).
Note: The Aerogen Pro-X Controller is approved for use
withAerogenAC/DCadapterAG-AP1040-US(Manufacturer
Reference: FRIWO FW7660/09)
PowerConsumption < 8 Watts (charging), 2.0 Watts (nebulizing).
Patient Isolation
Controllercircuitryprovides4kilovolt(kV)patientisolationand
complieswithIEC/EN60601-1.