TABLE OF CONTENTS
Safety Precautions 1
Section 1: Features 2
Section 2: Operating Principle 3
Section 3: Unpacking 4
Section 4: Mounting the Aerator 4
Section 5: TORNADO® Aerator Accessories 5
5.1: Mounting Accessories 5
5.2: Float Accessories 6-8
Section 6: Float Mooring Options 9
6.1: Mooring to Shore 9
6.2: Proper Way to Clip Wire Rope 10
6.3: Mooring with Anchors 11
Section 7: Mooring Accessories 12
Section 8: Wiring the Aerator 12
8.1: Recommended Electrical Accessories 12
8.2: Cable Selection 13
8.3: Electrical Accessories 13
Section 9: Start Up 14
9.1: Training 14
9.2: Propeller Rotation 14
9.3: Amp Draw 15
9.4: Observation of Operation 15
Section 10: Aligning the Coupling 15
Section 11: Maintenance Schedule 16
Section 12: Troubleshooting 17
Section 13: Disassembly & Maintenance 18
13.1: Removing the Propeller 18
13.2: Removing the Draft Tube 18
Section 14: Service Policy 19
Class I TORNADO® Drawings
Start-Up Sheet
APPENDICES A – C
Propeller & Motor Seal Module Instructions
Electrical Cable Selection
U-Bolt Clip Instructions
TORNADO Parts Kits
APPENDIX D
Equipment Data Sheets
Aeromix Class 1 Tornado Aspirating Aerator - Installation Operation Maintenance - Vendor Manual
To Next Page