EasyManua.ls Logo

Aeromix Class I TORNADO - Section 8: Wiring the Aerator

Aeromix Class I TORNADO
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 7: MOORING ACCESSORIES
Mooring cable is available from
AEROMIX in a variety of sizes.
A chart in Appendix B shows
recommended mooring cable sizes.
Wire rope clips (also known as cable
clamps) and thimbles are sized for
different diameters of mooring cable.
Wire Rope Clip Thimble
Mooring Kit Quick Disconnect Eye Bolt
SECTION 8: WIRING THE AERATOR
ALL WIRING MUST BE DONE BY A QUALIFIED ELECTRICIAN IN
ACCORDANCE WITH LOCAL ELECTRICAL CODES. AEROMIX is not
responsible for motors that have failed due to improper wiring.
8.1: RECOMMENDED ELECTRICAL ACCESSORIES
Electrical accessories such as power cable, watertight electrical cable clamps, and
control panels are normally not supplied; however, these accessories can be ordered
separately from AEROMIX.
Ground Fault Interruption (GFI) devices or equivalent protection must
be used if this equipment is to be used where people come in contact
with water.
-12-
Aeromix Class 1 Tornado Aspirating Aerator - Installation Operation Maintenance - Vendor Manual
Q-Pulse Id: VM483
Active: 11/11/2015
Page 23 of 30