Need help?Do you have a question about the AeroWorks 50cc EXTRA 260 ARF-QB and is the answer not in the manual?
Defines the purpose and recommended user for the aerobatic plane.
Guides the installation of servos for the ailerons on the wing.
Details the process of connecting the aileron servos to the control surfaces.
Outlines the steps for installing servos for the elevators onto the horizontal stabilizer.
Explains how to connect the elevator servos to the control surfaces.
Covers the process of attaching the rudder to the vertical fin using hinges.
Details the installation of the rudder servo into the fuselage.
Explains the setup of the pull-pull cable system for the rudder control.
Describes the mounting of control horns for the rudder linkage.
Provides instructions for assembling and installing the tail wheel mechanism.
Guides the installation of the main landing gear strut onto the fuselage.
Details the process of mounting wheels and wheel pants to the landing gear.
Covers the initial steps and considerations for mounting the engine.
Specific instructions for installing rear-carburetor engines with mufflers.
Instructions for installing tuned pipes or canister mufflers.
Prepares the fuselage for the installation of a canister muffler.
Prepares the fuselage for the installation of a tuned pipe.
Details the installation of servos for throttle and choke control.
Explains the options for installing a choke system.
Guides the mounting of the engine ignition module and battery.
Covers the assembly of the fuel tank components.
Details the routing and connection of fuel lines.
Provides instructions for applying decals to the model.
Explains how to find and adjust the center of gravity for optimal flight.
Details how to set and measure control surface deflections for flight.
To Next Page
General