Need help?Do you have a question about the AeroWorks Extra 260 and is the answer not in the manual?
General| Material | Foam |
|---|---|
| Power | Electric |
| Battery | 7.4V 850mAh LiPo |
| Radio | 4CH |
| Assembly | Some assembly required |
Details the notification period and process for warranty claims.
Lists hardware for DLE 30 engine installation.
Lists hardware for DLE 35RA engine installation.
Lists recommended servos for sport flying performance.
Lists recommended servos for unlimited aerobatic performance.
Specifies the recommended spinner size for the model.
Details receiver requirements for optimal control mixing.
Instructions for using the universal engine mounting template.
Specific installation steps for DLE 30 and DLE 35RA engines.
Guides on measuring aileron and elevator control throws.
Instructions for measuring rudder control throws using a meter.
Demonstrates measuring control surface deflection in degrees.
Guidance for initial flights on low rates for familiarization.
Key areas to check for long-term airframe durability.
Outlines safety precautions for handling Lithium Polymer batteries.
Lists parts specific to the fuselage and vertical fin assembly.
Details components included with the left wing and aileron.
Details components included with the right wing and aileron.
Lists parts for the inner Side Force Generators.
Lists parts for the outer Side Force Generators.
Lists components for the horizontal stabilizer and elevator.
Lists parts for the rudder assembly.
Lists parts for the main landing gear assembly.
Lists the main wheels included in the kit.
Lists the painted wheel pants included in the kit.
Lists parts for the tail wheel assembly.
Lists control horns and pushrods for various control surfaces.
Lists pull-pull cable hardware for rudder control.
Lists carbon fiber tubes for wings and stabilizers.
Lists components for the fuel tank assembly.
Lists parts related to the aircraft cowling.
Lists components for throttle servo installation.
Lists parts required for choke mechanism setup.
Lists general parts for engine and assembly, including templates.
Lists the "CG Buddy" for center of gravity checks.
Lists the dimensions of the covering material sheets.
Mentions the included custom decal sheet.
Notes the inclusion of an instruction manual CD.
Aeroworks throw meter for precise control throw setting.
Lightweight carbon tail wheel for enhanced strength.
2.5 gallon hand crank gas fuel system for powered aircraft.
Kit providing components for plumbing gasoline-powered aircraft.
Safety clips for securing servo connections.
Protective bags designed for wings and stabs.
To Next Page