Need help?Do you have a question about the AeroWorks 35cc EXTRA 300 ARF-QB and is the answer not in the manual?
General| Weight | 9.5-10.5 lb (4.3-4.8 kg) |
|---|---|
| Engine Size | 30-35cc gas |
| Construction | Balsa and plywood |
| Covering | Ultracote |
| Skill Level | Advanced |
| Radio System | 4+ channels |
Covers main landing gear, tail wheel, pushrods, and pull-pull cables for controls.
Details fuel tank assembly, engine mounting templates, and associated hardware.
Lists essential hardware, tools, and adhesives required for assembly.
Specifies required RC components like servos, receiver, batteries, and engine types.
Instructions on using a covering iron and heat gun to tighten and smooth the aircraft's covering.
Steps for installing the aileron servos, including extensions and wiring.
Steps for installing the elevator servos, including extensions and wiring.
Instructions for attaching control horns and pushrods to the elevators.
Steps for epoxying hinges to the rudder and fin for secure attachment.
Mounting engine rails, checking measurements, and securing the engine.
Cutting exhaust and hot air exit holes, and trial fitting the cowl for proper clearance.
Instructions for balancing the aircraft by measuring the CG at the wing tip.
Using tools to measure throws for ailerons, rudder, and elevators in inches and degrees.
To Next Page