Need help?Do you have a question about the AeroWorks EXTRA 260 FREESTYLE QB-L and is the answer not in the manual?
Details the wing span and area of the aircraft.
Specifies fuselage length, cowl width, and aircraft weight.
Lists compatible motor options and minimum radio channel requirements.
A brief introduction to the Aeroworks 52" Extra 260 Freestyle QB-L.
Details the warranty terms, period, and claims process.
Lists all parts included in the aircraft kit.
Lists hardware, tools, and adhesives needed for assembly.
Instructions for tightening and reshrinking the aircraft's covering.
Procedure for reinforcing all seams and glue joints with CA.
Instructions for gluing the ailerons to the wings using CA hinges.
Using a straight edge to ensure the aileron sits flush with the wing tip.
Applying thin CA to hinges after removing T-pins for security.
Steps for scuffing, positioning, and gluing the control horn and servo.
Taping the servo lead inside the wing to prevent it from falling back.
Instructions for assembling and adjusting the aileron pushrod linkage.
Steps for installing both inner and outer Side Force Generators (SFGs).
Ensuring proper alignment and centering of the stabilizer using measurements.
Instructions for gluing the stabilizer and installing elevator hinges.
Installing the elevator servo in the servo well.
Assembling the elevator pushrod linkage components.
Installing the tail wheel assembly and rudder control horn.
Securing the rudder hinges after checking deflection.
Installing the rudder servo in the servo well.
Feeding, routing, and securing the pull-pull cables.
Steps for attaching the main landing gear strut and wheel pants.
Installing the motor, standoff blocks, and propeller adapter.
Mounting the ESC and installing the air scoop for cooling.
Steps for fitting and mounting the cowling, propeller, and spinner.
Mounting the receiver and securing the battery in the fuselage.
Instructions for cutting and applying the aircraft's decals.
Procedure for checking the aircraft's Center of Gravity using the CG Buddy.
Final checks before flight, including cowl and wing mounting.
Defines low, medium, and high rate deflection settings for control surfaces.
Instructions on how to use the throw meter to measure control surface deflections.
Guidance for initial flights, including takeoff and low-speed handling.
Lists essential items to check before each flying session.
Safe charging procedures and precautions for Lithium Polymer batteries.
Summary of key safety code provisions for model aircraft.
Details restrictions on propellers, fuels, and flying under influence.
Guidelines for safe radio control operations at flying sites.
To Next Page
General