4 Aeroworks 30cc Freestyle Extra 260 Assembly Manual
HARDWARE NEEDED TO
COMPLETE
Engine Option 1: DLE 30
◊ 1 - DLE 30 Rear Carb w/ 60mm Standoffs
◊ 1 - J’Tec Wrap Around Pitts Muffler
◊ 8 - Fender Washers
◊ 8 - Engine mounting bolts
◊ 1 - 18x8 Propeller
Servo Option 1 : Sport Performance
Hitec 7985MG Servos may be used for sport flying.
If flying more aggressive aerobatics please see
Servo Option Two below.
Note: Servos available through Aeroworks
◊ 5 - Hitec 7985MG Servos for flight surfaces
◊ 1 - Hitec 635HB Servo for throttle
Servo Option 2: Unlimited Performance
Hitec 7954SH Servos are recommended for unlim-
ited flying. These servos will provide the best per-
formance possible.
Note: Servos available through Aeroworks
◊ 5 - Hitec 7954SH Servos for flight surfaces
◊ 1 - Hitec 635HB Servo for throttle
Recommended Spinner:
◊ 1 - 3” Carbon Spinner
Note: Spinner available from Aeroworks
Electronic Accessories : Receiver
A 6 or 8 channel receiver is recommended, using a
receiver with 6-8 channels will allow the builder to
mix both the aileron and elevator servo together in
the radio. Mixing these functions will result in a great
flying, well trimmed airplane.
◊ 1 - 6-8 Channel 2.4 GHz or PCM Receiver
Engine Option 2: DLE 35RA
◊ 1 - DLE 35RA w/ 60mm Standoffs
◊ 1 - Stock DLE 35RA Muffler
◊ 8 - Fender Washers
◊ 8 - Engine mounting bolts
◊ 1 - 19x8 Propeller
To Next Page
Loading...
