32 Aeroworks 30cc Freestyle Extra 260 Assembly Manual
7. Mount switch in accordance with the switch
manufacturers instructions and hardware.
8. Mount ignition regulator as desired. Secure all
connectors with tape, safety clip or similar.
1. Gather the fuel tank parts as shown below.
Required Parts
◊ 1 - 450cc (15oz) Gas Tank
◊ 1 - Rubber Stopper (Universal)
◊ 3 - Brass Tubes
◊ 1 - Aluminum Stopper Front Plates
◊ 1 - Aluminum Stopper Back Plates
◊ 1 - Phillips Head Bolts
◊ 2 - Brass Barbs for Fuel Line
◊ 2 - Small Nylon Ties
Required Parts -Not Included
◊ 1 - Aeroworks Fuel Line Installation Kit
Required Tools and Adhesives
◊ Pencil/Felt Tip Pen
◊ Phillips Screw Driver
◊ Wire Cutter
◊ Soldering Iron
◊ Silver Solder “Sta-Brite Recommended”
◊ 80 Grit Sandpaper
FUEL TANK ASSEMBLY
Fuel Line
Installation
Kit avail-
able sepa-
rately from
Aeroworks
2. Locate the (2) supplied brass fuel barbs. Solder a
brass fuel barb to the fuel line pick up tube. This
will keep the weight of the fuel clunk from pull-
ing the fuel line off the brass tube.
Note: No brass barbs are
required for the air
vent lines.
3. Assemble the fuel pick up line, rubber stopper
and metal end caps. As shown below.
To Next Page
Loading...
