5
ASSEMBLY
NOTE: Do not plug in the vacuum until it is completely assembled.
Attaching the Handle to the Vacuum
The vacuum cleaner and the handle are packed
separately and require assembly.
1. Thread the cord through the lower and upper cord
guides on the back of the vacuum bag (Fig. 1).
2. Remove the handle bracket by removing the two
screws (Fig. 2).
3. Place handle onto the back of the vacuum, aligning
holes with pegs (Fig. 3).
4. Place the handle bracket back into position (Fig. 4).
5. Secure with two screws removed in Step 2.
6. Unzip the outer bag compartment to ensure a
vacuum bag is in place.
7. Close the outer bag. Your vacuum is now ready
for use.
Unwinding the Power Cord
The lower cord hook rotates to allow for quick access
to the power cord.
Turn the lower cord hook upward and you can quickly
drop the power cord to the oor without unwinding it
from the cord hooks.
When storing the vacuum cleaner, turn the lower cord
hook to the downward position and wind the power
cord clockwise around the top and bottom cord hooks.
Fasten the plug to the wrapped cord using the channel
on the plug.
To Next Page
Loading...
