AFG 18.1AXT - Page 17

18
ASSEMBLY STEP 9
NUT (G)
WASHER (L)
BOLT (N)
SPACER
SPACER
ROD BEARING SHAFT
LINK ARM
LOWER HANDLEBAR
A Open HARDWARE FOR STEP 9.
B Slide ROD BEARING SHAFT into the end of
the LINK ARM. Align end of LINK ARM with
bracket on bottom of LOWER HANDLEBAR.
C Place SPACERS on both sides of the
LINK ARM. While holding SPACERS slide
LINK ARM into bottom end of LOWER
HANDLEBAR.
D Secure the joint using 1 BOLT (N), 1 WASHER
(L) and 1 NUT (G).
E Repeat on opposite side.
HARDWARE FOR STEP 9:
WASHER (L)
18 mm
Qty: 2
BOLT (N)
45 mm
Qty: 2
ROD BEARING
SHAFT
Qty: 2
SPACER
Qty: 4
NUT (G)
8 mm
Qty: 2