AG Neovo TX-1502 - User Manual

Questions and Answers

R
Ronald GriffithAug 7, 2025
What to do if my AG Neovo TX-1502 Monitor has no picture?
- D
  Dylan YoungAug 7, 2025
  If your AG Neovo Monitor isn't displaying a picture, ensure it's powered on and the power adapter is correctly connected both to the monitor and the power outlet. Verify that the monitor is properly connected to the input source, and that the input source is also turned on and not in standby mode (try moving the mouse or pressing a key). Avoid using the USB cable to charge your laptop, as this can prevent the monitor from waking up when you touch the screen.
B
bsandovalAug 10, 2025
Why is my AG Neovo TX-1502 Monitor displaying a partial image?
- J
  Julie CarlsonAug 11, 2025
  If the image on your AG Neovo Monitor is partial or displayed incorrectly, check if your computer's resolution exceeds the monitor's capabilities. For optimal display, reconfigure your computer's resolution to be less than or equal to 1024 x 768 (for TX-1502), 1280 x 1024 (for TX-1702/1902), or 1920 x 1080 (for TX-2202).
H
hooverbrianAug 14, 2025
How to adjust image position on AG Neovo Monitor?
- B
  Bradley DuncanAug 15, 2025
  If the image position is incorrect on your AG Neovo Monitor when using VGA input, adjust the 'H-Position (Horizontal Position)' and 'V-Position (Vertical Position)' settings within the Picture menu.
T
Tammy AdamsAug 19, 2025
Why are texts blurry on my AG Neovo Monitor?
- B
  Briana TaylorAug 19, 2025
  If the texts displayed on your AG Neovo Monitor appear blurry when using VGA input, run the Auto Adjust function located in the Picture menu.
R
Rachel JacobsAug 25, 2025
What to do if static image shadows appear on AG Neovo Monitor?
- E
  Ethan RoweAug 25, 2025
  If you notice faint shadows from a static image appearing on your AG Neovo Monitor screen, try turning off the monitor for extended periods. You can also use a screen saver or a black and white image and run it for extended periods of time.
M
Mary TaylorAug 27, 2025
Why do colored dots appear on my AG Neovo TX-1502 Monitor?
- M
  meyercynthiaAug 28, 2025
  The appearance of red, blue, green, or white dots on the screen of your AG Neovo Monitor is usually due to a few damaged transistors. This is considered normal and not a failure.
S
Stephanie Sullivan MDSep 1, 2025
What to do if dew forms on my AG Neovo TX-1502?
- M
  Mr. Mark EllisSep 1, 2025
  Dew formation on your AG Neovo Monitor typically occurs when moving it from a cold to a warm environment. Do not turn on the monitor; instead, wait for the dew condensation to disappear.