AGA Ellesmere - Default Chapter; Installation Information - Please Complete

GB & IE
AGA Ellesmere Standard Gas Stove 3
Installation Information
Please complete the following form for reference when required:
Ref.
Description
Please Complete
1
Which retailer did you purchase the stove
from?
Name & Address of Retailer:
2
What date did you purchase your new
stove?
Date:
3
What was the name of the gas fitter that
installed your stove?
Full Name:
Contact Number:
4
What is the installer Gas Safe Registration
Number?
Gas Safe Registration No.:
5
What is the serial Number of your stove?
This can we found inside the front door above
the bottom hinge
Serial Number:
6
What date was your stove installed?
Date:
7.
The AGA Name, Model & Gas Type
reference for this stove is
Name - Ellesmere
Model - ECG Standard
Gas Type – Natural Gas
Controller - Maxitrol Mertik GV60
Technical Data Summary:
Reference
Description
Data
1
Nominal Heat Output – High Flame
4.37 kW
2
Efficiency %
81%
3
European Energy Label Rating (EEL Eco Labelling)
“A”
Who Can Fit My New AGA Gas Stove:
Before the Gas Engineer can commence working on this stove they must be Gas Safe -
qualified and registered for Natural Gas to install, commission and service this stove to the
Domestic Gas Safety (CCN1) standard as a minimum and also have the (HRT 1) Category
on their Gas Safe Individual Register listing which can be verified at
www.gassaferegister.co.uk
HTR 1 - Category = Fire/Space Heater - Competent in the install, exchange, commission,
disconnect, service, repair, safety checking and break down of domestic gas fires, wall
heaters, convector heaters, stoves and flueless gas fires.
The installation of this stove is Notifiable Under Building Control –
Building Regulation 2002 Part J
This Stove is set up for Natural Gas Only