AGA OC - Fire valve resetting; Operating your AGA; After your AGA has been erected

6
The re valve, located at the side of the appliance (See
Fig. 4.6) can be reset once the unit has sensed the correct
functional temperature.
Fire valve resetting
TO RESET: press button (See Fig. 4.7) and if the button stays
in, the appliance is fully functional again. If the button springs
out, more cooling time must be given before trying again.
In the event of the re valve frequently cutting-out, consult
your Aga Distributor.
NEVER ATTEMPT TO RELIGHT A HOT BURNER.
Operating your AGA
The following points are intended to help you during the
period of change-over from your previous cooker to the AGA
way of life.
You will also nd that the AGA Book provides a very useful
introduction to the cooker.
After your AGA has been erected
When it rst lit, your AGA will emit an odour for a short while.
Do not worry, this is simply due to protective oil burning
o the hotplates. If you can wipe the inside of the hotplate
lids whilst the AGA is heating up it will avoid a lm of this oil
being deposited on the inside of the lids.
FIRE VALVE
RESET BUTTON
DESN 510904 A
DESN 510904 A
Fig. 4.6
Fig. 4.7