AGA TC3 - Connection to the Power Supply; Electrical Safety and Connection

32
The rating plate is located behind the removable plinth, see Fig. 13.2.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualied person to avoid a hazard.
Electrical Grounding is required on this appliance.
DO NOT connect to the electrical supply until the appliance is permanently grounded.
This appliance must be connected to a grounded, metallic, permanent supply. Or a grounding
connector should be connected to the grounding terminal or wire lead on the appliance.
Failure to follow these instructions could result in death or serious injury.
13. Connection to the Power Supply
Electric Shock Hazard
This range must be supplied with a 240V, 60Hz power
supply and connected to an individual, properly grounded
branch circuit protected by a circuit breaker. At 240V, it has a
maximum load of 30 amps. Electric hook-up must be done by
a licensed electrician. This unit must be installed according
to regional codes, or in the absence of codes, the National
Electrical Code.
• Product installation requires a separate (not shared)
240V/40 amp circuit protected by an appropriate
branch circuit supply.
• The service cord on your range is fitted with a standard
four (4) prong type 14-50P plug (matching receptacle
14-50R).
The method of connection to the mains electricity supply
must facilitate complete electrical isolation of the appliance.
The mains connection and isolation should not be positioned
above the range and must be positioned within the area
dened in Fig. 13.2.
THIS RANGE MUST BE COMPLETELY ISOLATED FROM THE
ELECTRICITY SUPPLY BEFORE SERVICING. THE RANGE
IS DESIGNED FOR THE VOLTAGE STATED ON THE RATING
PLATE, WHICH IS SITUATED BEHIND THE PLINTH COVER.