3Unpacking the scanner
Preparing the scanner
This chapter assists you in preparing your StudioScan II for
installation. You’ll find instructions for:
■ Unpacking the scanner
■ Unlocking the scanner
■ Locking the scanner
■ Installing the Transparency Module
■ Testing the scanner
Unpacking the scanner
The first thing to do is to make sure you have everything you’re
supposed to.
1. Open the packing box and take out all the items.
2. Check each item against Figure 1 to make sure that you have
everything.
If something is missing, contact your dealer or representative.
3. Remove the plastic wrapping and the packing materials from
the scanner.
❖ Note: Save the packing materials so that you can repack the scanner to
protect it if you have to move it over long distances.
4. Fill out the Warranty and Registration card. You will find the
product serial number on the identity label on the rear of your
scanner.
To Next Page
Loading...
