10 Chapter 1 Preparing the scanner
Testing the scanner
You are now ready to perform a power-on test to check if the scanner
is operating correctly.
1. Check that you have unlocked the locking screw.
2. Connect the power cord to the scanner.
3. Turn on the scanner.
The Power indicator lights up and the Ready indicator flashes
briefly. The scanning lamp turns on.
The scanner performs a self-test after which the Ready indicator
turns on.
If the Power and Ready indicators fail to light up during the self-
test, refer to Appendix A, ‘Troubleshooting’.
To Next Page
Loading...
