AGFA StudioStar User Manual

StudioStar
Owner’s Guide
Preface
This chapter gives you information about StudioStar
™
and about the organization of this
Owner's Guide.
Chapter 1 — Preparing the scanner
It shows you how to prepare your StudioStar for installation.
Chapter 2 — Installing the scanner
“Installing the scanner” instructs you how to set up your StudioStar for the Apple
®
Macintosh
®
and for PC
™
.
Chapter 3 — Using the scanner
Chapter 3 shows you how to place your originals.
Appendix A — Using the transparency option
This appendix gives you instructions on how to connect the transparency option you may
have purchased.
Appendix B — Using the document feeder option
In this appendix you can read how to connect the document feeder option you may have
purchased.
Appendix C — Troubleshooting
“Troubleshooting” can be helpful when you come across problems that you are unable to
solve.
Appendix D — Technical information
This appendix provides technical specifications for your StudioStar.
Appendix E — Regulation compliance
It gives you information about safety regulations and electromagnetic interference.
abc
The complete picture.

AGFA StudioStar Specifications

General

Brand	AGFA
Model	StudioStar
Category	Scanner
Language	English

Summary

Installing the Scanner

SCSI Devices and Setup

Macintosh Installation

Step-by-step instructions for connecting and testing the StudioStar scanner with an Apple Macintosh computer.

PC Installation

Guide to installing the StudioStar scanner on a PC, including SCSI interface card selection and connection.

Using the Scanner

Placing Reflective Originals

Document Feeder Operation

Placing Transparent Originals

Troubleshooting

Scanner Calibration Error

Solutions for issues where the computer screen displays a scanner calibration error message.

Ready Indicator Failures

Diagnosing and resolving problems with the scanner's ready (yellow) indicator light not illuminating.

Scanner Lamp Problems

Troubleshooting advice for scanner lamps that flicker, dim, or fail to turn on.

"Scanner Not Ready" Message

Steps to resolve "Scanner not ready" or similar messages from the scanner driver software.

Scanner Startup and Noise Issues

Fixes for scanners that fail to start up or make banging noises when attempting to move.

Indicator Lights After Power-Up

Addressing issues where the ready indicator remains blinking or goes off after the power-up sequence.

Power Indicator Failure

Troubleshooting steps for when the scanner's power (green) indicator light does not turn on.

Macintosh Workstation Issues

Resolving problems where the Macintosh workstation fails to start up due to SCSI conflicts.

Scanner Software Connection Issues

Fixes for when the scanner software cannot detect or connect to the scanner.

Macintosh Scanning Errors