Chapter 1 — Preparing the scanner 11
Performing a power-on test
You are now ready to perform a power-on test to check if the scanner is operating correctly.
1. Check whether you have unlocked the scanner.
2. Connect the power cable to the scanner.
Make sure that you are using the correct power cable for the voltage in your area. Double-
check whether the voltage indicated on the back panel of the scanner corresponds with the
voltage in your area. If not, call your dealer.
3. Switch on the scanner.
The power indicator (green) lights up and the ready indicators flash briefly. The scanning lamp
turns on.
The scanner performs a self-test after which the ready indicator (the middle yellow one)
switches on. This takes about 15 seconds or less.
If a malfunction is detected during the self-test, that is, if the ready indicator remains off, refer to
Appendix C, “Troubleshooting”.
To Next Page
Loading...
