Appendix B — Using the document feeder option 39
Installing the document feeder option
Checkout
The ADF is delivered in assembled form, ready to be mounted onto the scanner. The first thing to
do is to make sure you have everything you are supposed to.
1. Open the packing box and take out all the items.
The ADF package includes the ADF and the Warranty Card.
2. Check each item to make sure that you have everything and that there is no visual defect.
If something is missing, contact your dealer.
3. Remove the plastic wrapping and the packing materials from the document feeder option.
4. Fill out the Warranty card. You will find the product serial number on the identity label at the rear
of your document feeder option.
❖ Note: Save the packing materials so that you can repack the document feeder option to protect
it if you have to move it over long distances.
Before you begin
Follow these steps before installing the ADF:
1. Install the scanner as described in this Owner's guide.
2. Make sure that the scanner, its peripherals, and the computer are all powered off. Unplug the
scanner's power cord.
Installation
You install the document feeder option as follows:
1. Check if your scanner is properly unlocked.
2. Turn off your scanner.
3. Turn off your computer.
4. If the transparency option is installed, disconnect it from your scanner, for it uses the same
connector.
5. Pull out the two pins holding the scanner's document cover and lift off the cover.
6. Place the ADF on top of the scanner. Insert the guide pins into the holes originally used by the
scanner's document cover.
To Next Page
Loading...
