AGFA StudioStar - Installing the Scanner

Chapter 2 — Installing the scanner 12
Chapter 2 — Installing the scanner
This chapter shows you how to set up your StudioStar with your Apple Macintosh or PC.
Minimum hardware requirements and recommendations
Environmental requirements
Precautions
Cleaning your scanner
SCSI devices
Installation for the Apple Macintosh
Choosing a SCSI ID number
Connecting the scanner
Testing the connection
Installation for the PC
Which SCSI interface card
Choosing a SCSI ID number
Connecting the scanner
Testing the connection
Installation of the software
Minimum hardware requirements and recommendations
■ For the Apple Macintosh:
n
A 68020 processor.
n
A 13" color monitor.
n
A 24-bit video card for an accurate display of color images.
n
5 Mb of RAM (8 Mb recommended).
n
A high-capacity disk drive.
n
System 7.0™ or higher.
n
The amount of disk space available on your Macintosh determines the number and the
size of the images you can scan. Make sure you have enough free storage space on your
hard disk. You need about two times the size of the image to scan, edit and save it. You
need minimum 30 Mb free hard disk space and 8 Mb of RAM for color images.