Agilent Technologies 34970A - Low-Cost Switching Solutions; Module Functionality and Design; Easy Scanning Control

Mx+B Scaling Commands
(see page 244 in the User’s Guide)
CALCulate
:SCALe:GAIN <
gain>[,(@<ch_list>)]
:SCALe:GAIN? [(
@<ch_list>)]
:SCALe:OFFSet <offset>[,(@<ch_list>)]
:SCALe:OFFSet? [(
@<ch_list>)]
:SCALe:UNIT <
quoted_string>[,(@<ch_ list>)]
:SCALe:UNIT? [(
@<ch_list>)]
CALCulate:SCALe:OFFSet:NULL [(
@<ch_list>)]
CALCulate
:SCALe:STATe {OFF|ON}[,(@<ch_list>)]
:SCALe:STATe? [(@<ch_list>)]
Alarm Limit Commands
(see page 247 in the User’s Guide)
OUTPut
:ALARm[
1|2|3|4]:SOURce (@<ch_list>)
:ALARm[
1|2|3|4]:SOURce?
CALCulate
:LIMit:UPPer <
hi_limit>[,(@<ch_ list>)]
:LIMit:UPPer? [(@<ch_list>)]
:LIMit:UPPer:STATe {OFF|ON}[,(
@<ch_list>)]
:LIMit:UPPer:STATe? [(
@<ch_list>)]
CALCulate
:LIMit:LOWer <
lo_limit>[,(@<ch_ list>)]
:LIMit:LOWer? [(
@<ch_list>)]
:LIMit:LOWer:STATe {OFF|ON}[,(
@<ch_list>)]
:LIMit:LOWer:STATe? [(
@<ch_list>)]
SYSTem:ALARm?
OUTPut
:ALARm:MODE {LATCh|TRACk}
:ALARm:MODE?
:ALARm:SLOPe {
NEGative|POSitive}
:ALARm:SLOPe?
OUTPut
:ALARm{1|2|3|4}:CLEar
:ALARm:CLEar:ALL
STATus
:ALARm:CONDition?
:ALARm:ENABle <
enable_value>
:ALARm:ENABle?
:ALARm[:EVENt]?
Ch 01
DIO (LSB)
Ch 02
DIO (MSB)
Ch 03
Totalizer
Ch 04
DAC
Ch 05
DAC
CALCulate
:COMPare:TYPE {EQUal|NEQual}[,(@<ch_list>)]
:COMPare:TYPE? [(
@<ch_list>)]
:COMPare:DATA <
data>[,(@<ch_list>)]
:COMPare:DATA? [(@<ch_list>)]
:COMPare:MASK <
mask>[,(@<ch_list>)]
:COMPare:MASK? [(
@<ch_list>)]
:COMPare:STATe {OFF|ON}[,(
@<ch_list>)]
:COMPare:STATe? [(
@<ch_list>)]
This command applies to all channels in the instrument (Global setting).
Default parameters are shown in bo ld.
10