Agilent Technologies 4339B - Page 57

4339B
Preparation
for
Use
Turning
ON
the
4339B
1. Connect
the power
cable to
Power
Cord Receptacle
on the
rear panel.
2. Push
the LINE
switch in.
The 4339B
will emit
abeep
and start
the
self
test.
(If
any
message
is
displayed, refer
to the
\Messages" in
the
back
of
this
manual.)
The
4339B
will
be
ready
for
operation after
a message
similar to
the one
shown
in
the
following
gure
is displayed.
3.
When you
turn
on
the
4339B
for
the
rst
time
,
conrm
the
power
line
frequency
is
set
correctly
.
a.
Press
.
The following
menu
is
displayed.
b.
Press
until
more
blinks
,and
press
.
c.
Press
until
Line
blinks
,
and
press
.
A blinking item means that it is currently selected.
d. If the setting does not match the power line frequency
, press
to toggle the setting
between 50 Hz and 60 Hz
. Then press
.
e. Press
until Exit blinks, and press to exit this menu.
The power line frequency setting is stored and is not changed after reset or power-o. Once
you set it, you do not need to set the line frequency again as long as the same power line
frequency is being used.
Getting Started 1-13