Agilent Technologies 4395A - Page 61

Rack/Handle
Installation
Option
1CM
Rack
Mount
Kit
Option
1CM
is
a
rack
mount
kit
containing
a
pair
of anges
and the
necessary hardware
to
mount
them
to
the
instrument
in
an equipment
rack with
482.6 mm
(19 inches)
horizontal
spacing.
Mounting
the
Rack
1.
Remove
the
adhesive-backed
trim
strips
1 
from the
left and
right front
sides
of
the
4395A
.
2.
Attach
the
rack
mount
ange
2 
to the
left and
right front
sides
of
the
4395A
using
the
screws
provided.
3.
Remove
all
four
feet
(lift
bar on
the inner
side of
the foot,
and
slide
the
foot
toward
the
bar).
Option
1CP Rack
Mount &
Handle
Kit
Option
1CP is
arack
mount
kit
containing
a
pair
of
anges
and
the
necessary
hardware
to
mount
them
to an
instrument
which
has
handles
attached,
in
an
equipment
rack
with
482.6
mm
(19
inches)
spacing.
Mounting
the
Handle
and
Rack
1.
Remove
the
adhesive-backed
trim
strips
1

from
the
left and
right front
sides
of
the
4395A
.
2.
Attach
the front
handle 3

and
the
rack
mount
ange
5

together
on
the
left
and
right
front
sides
of
the
4395A
using the
screws
provided.
3.
Remove
all
four
feet (lift
bar
on
the
inner
side
of
the
foot,
and
slide
the
foot
toward
the
bar).
Connecting
Cables
Use
shielded
cables
when
you
connect
the DUT
and accessories
for testing.
F
or
more
information
about
the
cables
,
see chapter
12.
Installation Guide 2-9